October 20, 2008

Right fuel cap & drain fitting

Category: Fuel tanks — Steffen @ 23:13 — Hours: 3.5

Today after work I made the two clips that will support the vent line just forward of the fuel cap. I formed them around a 6mm pin extractor.

Then I riveted on the fuel trap doors..

After that I mixed up 20g of sealant and sealed all the rivet shop heads. I tried to use a syringe, but it didn’t work very well, so I ended up using the brush.

Next thing I did was rivet on the fuel cap flange. Still need to seal the shop heads, I’ll do that tomorrow.

Finally I riveted on the fuel drain fitting… that’s all for tonight!

Hacked by ghost-dz