{"id":1519,"date":"2009-02-12T22:02:37","date_gmt":"2009-02-12T21:02:37","guid":{"rendered":"http:\/\/www.rv-7.dk\/?p=1519"},"modified":"2009-02-12T22:03:29","modified_gmt":"2009-02-12T21:03:29","slug":"seat-belt-anchors","status":"publish","type":"post","link":"https:\/\/www.rv-7.dk\/?p=1519","title":{"rendered":"Seat belt anchors"},"content":{"rendered":"

I spent some more time working on the F-705\u00a0bulkhead tonight. I started by marking and drilling the bolt holes on all the left seatbelt anchors…
\n\"bulkheads-050-400x\"<\/p>\n

\"bulkheads-051-400x\"<\/p>\n

Then I installed these anchors, and clamped the right anchors to them with a 3\/16″ spacer in between. With these aligned and clamped, I could drill them using the bulkhead as guide. After all eight anchors were drilled, I trimmed the flanges of the 4 outboard anchors, to make room for some rivets.
\n\"bulkheads-052-400x\"<\/p>\n

Next I worked a bit on the big angles I cut the other day. They support the upper corners of this bulkhead, which is where the canopy will latch into. I clamped it in place on the bulkhead.
\n\"bulkheads-053-400x\"<\/p>\n

Then I flipped the bulkhead over and matchdrilled the angle. There is also a small slot for the canopy latch, that had to be made. I drilled a hole in each end of the slot, and used a small grinder and files to shape it.
\n\"bulkheads-054-400x\"<\/p>\n

\"bulkheads-055-400x\"<\/p>\n

An almost finished reinforcement angle, I still need to trim of about \u00bc\u201d of this flange.
\n\"bulkheads-056-400x\"<\/p>\n

\"bulkheads-057-400x\"<\/p>\n

\"bulkheads-058-400x\"<\/p>\n

\u00a0<\/p>\n