{"id":2811,"date":"2011-06-07T22:12:35","date_gmt":"2011-06-07T21:12:35","guid":{"rendered":"http:\/\/www.rv-7.dk\/?p=2811"},"modified":"2012-08-05T20:24:57","modified_gmt":"2012-08-05T19:24:57","slug":"baggage-bulkhead-nutplates","status":"publish","type":"post","link":"https:\/\/www.rv-7.dk\/?p=2811","title":{"rendered":"Baggage bulkhead nutplates"},"content":{"rendered":"

Besides cleaning up a bit in the garage – again!! – I worked a bit on the baggage bulkhead. First I marked and pilotdrilled the screw holes of the upper bulkhead.
\n\"\"<\/a><\/p>\n

Also marked the notch where the shoulder harness cable will pass through..
\n\"\"<\/a><\/p>\n

Then I taped the upper bulkhead in place, rechecked alignment and matchdrilled the screw holes to the\u00a0F-706 bulkhead.
\n\"\"<\/a><\/p>\n

I enlarged the holes to #30, so I could use cleco’s to\u00a0install nutplates as drill guides.
\n\"\"<\/a><\/p>\n

Here the upper nutplates are installed with cleco’s ready to drill.
\n\"\"<\/a><\/p>\n

I installed the nutplates on the vertical bellcrank rib with a screw and spacer nut as guide..
\n\"\"<\/a><\/p>\n

Rivet holes drilled. I countersunk these holes, but dimpled all the remaining rivet holes.
\n\"\"<\/a><\/p>\n

Finally I installed all the bulkhead nutplates. I forgot to take a last photo before calling it quits..<\/p>\n