{"id":2825,"date":"2011-07-19T20:29:16","date_gmt":"2011-07-19T19:29:16","guid":{"rendered":"http:\/\/www.rv-7.dk\/?p=2825"},"modified":"2012-08-05T20:24:49","modified_gmt":"2012-08-05T19:24:49","slug":"finished-baggage-bulkhead","status":"publish","type":"post","link":"https:\/\/www.rv-7.dk\/?p=2825","title":{"rendered":"Finished baggage bulkhead"},"content":{"rendered":"

I\u00a0spend a few hours tonight finishing up the \ufeffbaggage bulkhead.<\/p>\n

Actually \ufeff\ufeffI began making the shoulder seatbelt cable wearblocks more than 3 weeks ago though, but forgot to post the photos.\u00a0
\nBack then I \ufeffdrilled\u00a0the end of the cable notches to final size, then I marked and cut the notches..
\n\"\"<\/a><\/p>\n

Here er the wear block parts
\n\"\"<\/a>
\nI matchdrilled the upper wear blocks to the baggage bulkhead.
\n\"\"<\/p>\n

…then drilled the wear block notch\u00a0hole from the other side.
\n\"\"<\/a><\/p>\n

I used a sharp Stanley knife to cut the wear block notch.
\n\"\"<\/a><\/p>\n

This strip is used for wear block washers. I started by drilling the holes, it’s easier than after they get cut to size.
\n\"\"<\/a><\/p>\n

Then cut them to size!
\n\"\"<\/a><\/p>\n

This is where I started of tonight, I deburred the baggage bulkhead.
\n\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

Then I used a nutplate as drill guide for the missing screw holes below the wear blocks.
\n\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

I also drilled the rivet hole for the lower wear blocks..
\n\"\"<\/a><\/p>\n

Then I prep’d the aft tunnel cover.
\n\"\"<\/p>\n

Finally I removed and ‘de-blue’ed’ the upper skins.
\n\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

<\/a><\/p>\n