{"id":3438,"date":"2015-07-29T21:14:36","date_gmt":"2015-07-29T20:14:36","guid":{"rendered":"http:\/\/www.rv-7.dk\/?p=3438"},"modified":"2020-07-07T20:10:14","modified_gmt":"2020-07-07T19:10:14","slug":"roll-bar-construction-part-3","status":"publish","type":"post","link":"https:\/\/www.rv-7.dk\/?p=3438","title":{"rendered":"Roll bar construction, part 3"},"content":{"rendered":"

Finally! The roll bar parts are done and primed! I thought I would never finish them.. \ud83d\ude09
\nI still had a bit of drilling to do, like the forward splice plate…
\n\"Fuselage<\/a><\/p>\n

Then I had a LOT of countersinking to do. To access the inner holes, I had to clamp the roll bar to the edge of the table.
\n\"Fuselage<\/a><\/p>\n

\"Fuselage<\/a><\/p>\n

Only the forward sections gets countersunk for the splice plate.
\n\"Fuselage<\/a><\/p>\n

Last thing to get drilled was the F-632D angle. The holes ended up a little close to the radius of the angle. I didn’t notice that the splice plate was supposed to sit right against the lower radius of the sections, which would have placed the holes more towards the centre of this angle. A well, it will still be ok. Pictures will follow on the next post while riveting.
\n\"Fuselage<\/a><\/p>\n

After a lot of deburring and prep’ing, the parts were finally ready for primer.
\n\"Fuselage<\/a><\/p>\n

\"Fuselage<\/a><\/p>\n