\n
![\"Canopy](\"http:\/\/www.rv-7.dk\/wp-content\/Canopy-001-1600x.jpg\")
<\/a><\/p>\nThen drill the lower holes through the thin block, marking the alu spacer. Then removed\u00a0them, and completed the holes in the drill press. Finally I put them back in, installed the skin temporary to align the small ribs, then drill the holes through these as well. I also removed the F-697 subpanel reinforcement, and fitted the canopy release bellcrank block. Riveted it in place… …then clecoed the centre subpanel back in. Next up was the rods that connects the canopy hinge pins to the release bellcrank. I used a cutting disc in my drill press, worked like a charm! \ud83d\ude42 \u00a0To make the wide gap in the hinge pin ends, I simply rotated the tubes, and made another cut. To make room for the tubes, I had to modify \u00a0F-697 subpanel reinforcement I little. \u00a0 Also had to make a slot in the F-643 channel. \u00a0Not too bad.. \ud83d\ude42 \u00a0
\n<\/a><\/p>\n
\n<\/a><\/p>\n
\n<\/a><\/p>\n
\nIt is installed with 2 nutplates.
\n<\/a><\/p>\n
\n<\/a><\/p>\n
\n<\/a><\/p>\n
\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n
\n<\/a><\/p>\n
\n<\/a><\/p>\n
\n<\/a><\/p>\n
\n<\/a><\/p>\n<\/a><\/p>\n