{"id":433,"date":"2008-07-09T22:51:13","date_gmt":"2008-07-09T20:51:13","guid":{"rendered":"http:\/\/www.rv-7.dk\/?p=433"},"modified":"2020-06-21T07:53:12","modified_gmt":"2020-06-21T06:53:12","slug":"wing-walk-way-doublers-2%c2%bdh","status":"publish","type":"post","link":"https:\/\/www.rv-7.dk\/?p=433","title":{"rendered":"Wing walkway doublers"},"content":{"rendered":"

I spend almost 2\u00bd hours in the shop tonight, and even though it didn’t look like much, I got a lot of small things done.<\/p>\n

First I taped the wing walk-way doublers in place under the inboard top skins.
\n\"\"<\/p>\n

Then I flipped the skin over and drilled all the holes from the prepunched holes in the skin.
\n\"\"<\/a><\/p>\n

With all the holes drilled, I could fit the doubler to the wing ribs…
\n\"\"<\/a><\/p>\n

After the skins were cleco’ed back on I was short on cleco’s, so I decided to set the tanks aside for now. I removed the tank skins, marked all the stiffeners for position and removed those also. Then I removed the leading edges and started finetuning the wings in the stand. I hung plumbs in each end to check the twist in the wings, and adjusted the lower spar a little bit. Blurry picture, I know, I am still using my fathers old camera since mine is broken.
\n\"\"<\/a><\/p>\n

My plan is to install the bottom skins next, then matchdrill all the skins to the skeleton. I might see if I can borrow some more cleco’s from work..<\/p>\n