{"id":5056,"date":"2021-02-27T12:52:33","date_gmt":"2021-02-27T11:52:33","guid":{"rendered":"https:\/\/www.rv-7.dk\/?p=5056"},"modified":"2021-04-29T07:08:25","modified_gmt":"2021-04-29T06:08:25","slug":"quadrant-parking-brake-intake-duct","status":"publish","type":"post","link":"https:\/\/www.rv-7.dk\/?p=5056","title":{"rendered":"Quadrant, parking brake & intake duct"},"content":{"rendered":"

I forgot to add this to my last post, but I installed the Throttle Quadrant a while back.
\nI used nutplates, and spacers at the aft mounts.
\n\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

While waiting for replacement angles for the intake duct filter mount, I fabricated a bracket for the parking brake valve.
\nThe bracket needed an arm to hold the cable as well, I used cardboard to make a template for that.
\n\"\"<\/a><\/p>\n

The result..
\n\"\"<\/a><\/p>\n

Parts deburred and ready for primer.
\n\"\"<\/a><\/p>\n

I decided a good spot for the valve, and matchdrilled it to the firewall.
\nI still need to buy the fittings and collars for it.
\n\"\"<\/a><\/p>\n

The angles I ordered from Vans finally arrived. The package was stuck in Memphis for over a week, due to a winter storm.
\nAfter carefully trimming angles to fit, I installed them with epoxy and blind rivets, then made a fillet with epoxy to close the corners and support the angles.
\n\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n