{"id":5314,"date":"2021-11-14T21:49:05","date_gmt":"2021-11-14T20:49:05","guid":{"rendered":"https:\/\/www.rv-7.dk\/?p=5314"},"modified":"2023-07-24T08:12:01","modified_gmt":"2023-07-24T07:12:01","slug":"firewall-parts-1","status":"publish","type":"post","link":"https:\/\/www.rv-7.dk\/?p=5314","title":{"rendered":"Firewall parts #1"},"content":{"rendered":"

I have had a quite productive week.
\nFirst, I had ordered som labels for my instrument panel. I had them made in transparent foil, with a matte surface.
\nI think that will work just fine..
\n\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

I decided to remove the engine & mount, to get access to the firewall.
\nI still need to add some stuff to it, besides, its a lot easier to reach inside while i do the wiring.
\n\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

I installed the parking brake valve. I made the bracket for it a little while ago<\/a>..
\n\"\"<\/a><\/p>\n

With that installed, I could make the two lines that go to the firewall fittings.
\n\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

I bought 2 stainless steel firewall passthroughs seal kits for the wiring.
\n\"\"<\/a><\/p>\n

This one is for the power connections.
\nUnfortunately the Master\/Starter relay bracket was in the way, but I figured I could trim the bracket a bit, and reuse the corner rivet..
\n\"\"<\/a><\/p>\n

Bracket removed..
\n\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

The fitting riveted in place. I added some firewall sealant to the flange before riveting.
\n\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

I drilled the mounting holes and installed the sensor manifold.
\nThe top sensor is for manifold press, the middle for oil press and lower is for fuel press.
\n\"\"<\/a><\/p>\n

I also need a wiring passthrough here, for the engine connections
\n\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n