{"id":5442,"date":"2022-01-21T19:58:33","date_gmt":"2022-01-21T18:58:33","guid":{"rendered":"https:\/\/www.rv-7.dk\/?p=5442"},"modified":"2022-01-21T19:58:33","modified_gmt":"2022-01-21T18:58:33","slug":"avionics-3","status":"publish","type":"post","link":"https:\/\/www.rv-7.dk\/?p=5442","title":{"rendered":"Avionics #3"},"content":{"rendered":"

I’m almost done with the CAN bus wiring now. I have prepared for the autopilot roll servo in the right wing, by making a loop long enough to reach the servo. Once the wing is installed, I can cut that loop and install the servo connector.<\/p>\n

The CAN bus runs from the PFD, to the Engine Module, then to the COM radio..
\n\"\"<\/a><\/p>\n

After the COM radio it runs to the autopilot pitch servo..
\n\"\"<\/a><\/p>\n

Then finally to the magnetometer.
\n\"\"<\/a><\/p>\n

With that wiring done, the PFD can now connect to all these.
\n\"\"<\/a><\/p>\n