{"id":5514,"date":"2022-03-20T18:05:43","date_gmt":"2022-03-20T17:05:43","guid":{"rendered":"https:\/\/www.rv-7.dk\/?p=5514"},"modified":"2022-03-20T18:05:43","modified_gmt":"2022-03-20T17:05:43","slug":"exhaust-system-adjustments","status":"publish","type":"post","link":"https:\/\/www.rv-7.dk\/?p=5514","title":{"rendered":"Exhaust system adjustments"},"content":{"rendered":"

I have been postponing finishing my exhaust system for a long time now.
\nThe last issue with the system, was missing clearance between the mufflers and the lower engine cowl.
\nTo adjust this, I had to grind down a weld on each manifold, to adjust the angle.
\nI carefully grinded most of the weld away with my angle grinder, then finished with files.
\n\"\"<\/a><\/p>\n

\n\"\"<\/a><\/p>\n

After that I reinstalled the exhaust system, fixing the mufflers temporary with tie-strips to keep them in place.
\nIts a little hard to see, but I have about 3\/4″ of clearance now.
\n\"\"<\/a><\/p>\n

I also finished the magneto wiring. This wiring also supplies RPM signal to the EFIS.
\n\"\"<\/a><\/p>\n