{"id":5548,"date":"2022-05-06T07:18:54","date_gmt":"2022-05-06T06:18:54","guid":{"rendered":"https:\/\/www.rv-7.dk\/?p=5548"},"modified":"2022-05-06T07:18:54","modified_gmt":"2022-05-06T06:18:54","slug":"finished-baffles-again","status":"publish","type":"post","link":"https:\/\/www.rv-7.dk\/?p=5548","title":{"rendered":"Finished baffles – again."},"content":{"rendered":"

After trimming the left and right forward baffles to fit the intake ducts, I had to make new baffle seals for them.
\nOnce again, I made templates. Here the templates are shown compared to the old seals.
\n\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

I had to do a little paint touch-up after trimming the baffles. I had some left over paint, so I also painted the brake reservoir and fuel selector valve plate.
\n\"\"<\/a><\/p>\n

After the paint had dried, I reinstalled the fuel valve and installed the brake reservoir.
\n\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

I also reinstalled the baffles, and riveted on the new seals.
\n\"\"<\/a><\/p>\n

The fit is quite good, but I need to trim a little of the seal in the front.
\n\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n