{"id":6265,"date":"2023-07-13T21:27:01","date_gmt":"2023-07-13T20:27:01","guid":{"rendered":"https:\/\/www.rv-7.dk\/?p=6265"},"modified":"2023-07-13T21:28:34","modified_gmt":"2023-07-13T20:28:34","slug":"final-assembly-2","status":"publish","type":"post","link":"https:\/\/www.rv-7.dk\/?p=6265","title":{"rendered":"Final assembly 2"},"content":{"rendered":"

It’s been a very long day, but I managed to finish all the exterior wiring, and tested that all was working.<\/p>\n

Here I am finishing the taxi light, strobe light and nav light wiring in the left wing.\"\"<\/a><\/p>\n

Left wing tip installed…
\n\"\"<\/a><\/p>\n

Strobe, nav and landing light wiring done in the right wing.
\n\"\"<\/a><\/p>\n

The wiring for the aileron autopilot servo took some time to complete.
\n\"\"<\/a><\/p>\n

\"\"<\/a><\/p>\n

I also finished the strobe unit wiring.
\n\"\"<\/a><\/p>\n

The last thing to finish wiring, was the pitot heat.
\nAfter that, I reinstalled the instrument panel, and tested it all.
\nEverything was working, the only issue was the aileron trim, that was wired in opposite direction. swapping two wires in the aileron trim mixer fixed that problem.<\/p>\n

Tomorrow I will start by installing the ailerons and flaps, then the engine controls.
\nHopefully I will be able to make the first engine start.. \ud83d\ude00
\n\"\"<\/a><\/p>\n