I spend a few hours tonight finishing up the baggage bulkhead.
Actually I began making the shoulder seatbelt cable wearblocks more than 3 weeks ago though, but forgot to post the photos.
Back then I drilled the end of the cable notches to final size, then I marked and cut the notches..
Here er the wear block parts
I matchdrilled the upper wear blocks to the baggage bulkhead.
…then drilled the wear block notch hole from the other side.
I used a sharp Stanley knife to cut the wear block notch.
This strip is used for wear block washers. I started by drilling the holes, it’s easier than after they get cut to size.
Then cut them to size!
This is where I started of tonight, I deburred the baggage bulkhead.
Then I used a nutplate as drill guide for the missing screw holes below the wear blocks.
I also drilled the rivet hole for the lower wear blocks..
Then I prep’d the aft tunnel cover.
Finally I removed and ‘de-blue’ed’ the upper skins.
